Monday, December 10, 2018
Friday, December 7, 2018
Thursday, December 6, 2018
Wednesday, December 5, 2018
Tuesday, December 4, 2018
Monday, December 3, 2018
Altium Designer : Creating Custom Board Outline and Keepout Area
Adding a keep-out area along the board outline is a good design practice. The recommended keep-out line thickness is 20 mil.
Subscribe to:
Posts (Atom)
Low power Pushbutton ON/OFF Controller solution from Linear Technology
All of the flexible timing circuitry required to debounce the on/off pushbutton is integrated within the LTC2950. For applications that ne...
-
This EMI filter includes a common-mode filter and a differential-mode filter. Generally Differential mode filter filters noise less than 3...
-
When designing a PCB board, it is important to determine the necessary clearance for screw holes. The table below shows the general screw si...