R1, R2, R3,
R4 & R8: Low excess noise metal Film
C1, C2
& C3: Input and output coupling
C4 : Noise
filter, C5: bypass
NOTE: Input
Cable to microphone must be shielded
Hot-Swap Circuits with Inrush Current Limiter
To provide continuous current sensing and limiting, this hot-swap circuit uses a PNP transistor and a current sense resistor of 0.333R. Wh...
-
This EMI filter includes a common-mode filter and a differential-mode filter. Generally Differential mode filter filters noise less than 3... -
When designing a PCB board, it is important to determine the necessary clearance for screw holes. The table below shows the general screw si...