When NC (normally close) is detected at the input, microcontroller will receive Low (0V) signal and that will be high (5V) for NO (normally close).
Subscribe to:
Post Comments (Atom)
Ultra-Precise, Current-Sense Amplifier
This ultra-precise current sense amplifier that can measure voltage drops across shunt resistor, R1 over a wide common mode range from 2....
-
Voltage divider resistor network is used to step monitored voltage down to the range as necessary for A/D conversion. Passive low-pass f... -
Import Changes from Schematics to PCB in Alitum as below. 1) Compile the Project 2) Design >> Import Changes From XXX.PrjPCB 3)Execut...
No comments:
Post a Comment